BarUp 271599, Manual

Page: 5 / 68

5
EN
Product descriptions
Lid
Magnet
Microswitch
Connection
Safety arm
Electric box
PCB panel
Power cord
Bottom base
On-off switch
Motor
Motor cover
Spout
Upper of spout
Blade
Screw
Container
Preparation before first use
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable). Keep the packaging for future
storage.
• Clean the appliance, see: Cleaning and mainte-
nance.
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
Operation
1. Make sure the switch is in “OFF” status.
2. Place the ice cubes into the container.
3. Cover the lid on the container so that the mag-
netic sensor is in contact with the end of the
safety arm.
WARNING:
Any attempt to by-pass the safety
interlock and use the appliance without its lid
may cause personal injury and /or damage to
the appliance.
4. Start the motor by pressing down the switch to
“ON”. Run the appliance to crush the ice in the
container ( It lasts about 30 seconds to finish
crushing ice cubes in full container).
5. Switch the motor off by pressing down the switch
again.
NOTE: Always wait until all components have
completely stopped before opening the lid.