E
n
g
li
sh
16
71503928/0 - rEV.00
01/2013
f ) EVAPORATOR ASSEMBLY REPLACEMENT
•
remove the top cover.
•
remove six screws securing the paddle shaft supports (two)
and the paddle motor support; then remove the paddle
motor/paddle shaft/supports assembly.
•
remove the bolts securing the evaporator supports (two) to
the cabinet.
•
Sideways remove the evaporator supports.
•
Unsolder the capillary tube, the hot gas solenoid valve tube
and the suction line.
•
To install the replacement evaporator assembly follow pre-
vious steps in reverse.
•
Install the replacement drier; thoroughly evacuate the sys-
tem and proceed with the refrigerant charge.
g) WATER RESERVOIR/TILTING LEVER/SUPPORT ASSEMBLY
REPLACEMENT
•
remove screws and top cover.
•
remove the gear motor/paddle shaft/support assembly.
•
remove the screws securing the evaporator supports (two).
•
Sideways remove one evaporator support support as well as
one reservoir gudgeon support.
•
Slightly lift the evaporator and remove the water reservoir
assembly.
•
To install the replacement water reservoir assembly follow
previous steps in reserve.
h) WATER INLET ELECTROVALVE REPLACEMENT
•
remove the rear panel.
•
Check that water supply is closed.
•
Disconnect the water supply connection pipe from the valve
and that of the electrovalve from the reservoir.
•
Break contact from the electrovalve and remove the screws
(two) securing the electrovalve to the relevant frame.
•
To install the replacement electrovalve follow previous steps
in reverse; before installing the water supply pipe check that
the gasket is not defective.
i) PADDLE MOTOR REPLACEMENT
•
remove the top cover.
•
remove six screws securing the paddle shaft supports (two)
and the paddle motor support.
•
Trace the electric wire leads of paddle motor and disconnect
the same; then remove the paddle shaft motor assy.
•
remove the paddle shaft assy from the paddle motor gud-
geon (or guide pin).
•
To install the replacement paddle motor follow previous
steps in reverse.
l) HARVEST MOTOR REPLACEMENT
•
remove the top cover.
•
remove the screws securing the harvest motor to the cabi-
net base.
•
remove the seeger from the cam pin.
•
Trace the electric wire leads of harvest motor and disconnect
the same; then remove the harvest motor/cam/support as-
sembly.
•
remove the lock pin securing the cam to the motor shaft
and the screws joining the harvest notor to the relative sup-
port.
•
Install the replacement harvest motor on the support and
apply the cam; make a Ø 3 mm hole on the motor shaft and
to do it take as a guide the hole already existing on the cam.
•
To install the replacement harvest motor assy follow previ-
ous steps in reverse.
Summary of Contents for Q150
