- 31 -
5.2 Operating
GASREQUIREMENTS
•
Gas connections and hose assembly must conform to local safety regulations.
•
Never use a gas cylinder with a damaged body, valve, collar, or foot ring. A dented or
rusty gas tank may be hazardous and should be checked out by a gas supplier.
•
Never connect this appliance to an unregulated gas source.
•
When the appliance is not in use, turn the gas cylinder „OFF“.
CONNECTING TO A GAS CYLINDER
•
Use 9 kg gas cylinder. Please refer to your gas supplier for suitable gas cylinder.
•
Refer to your gas supplier for instructions on the use of your gas cylinder.
WARNING! Fire Danger!
Only change gas cylinders outdoors or in a well ventilated area
away from naked flames and any other source of ignition.
•
The gas cylinder must always be used in an upright position.
•
Close the heater control knob by turning it fully clockwise.
•
Close the gas cylinder tap and then attach the regulator onto the gas cylinder.
•
Tighten all connections firmly and with a spanner where appropriate. The cylinder
should be placed on the cylinder base.
•
Check for leaks at all joints using a soap/water solution. If a leak is found, tighten the
joint and then retest.
CAUTION!
Before first use and after every gas cylinder change, gas delivery system
must be purged of air before igniting! To do so, turn the control knob anti-
clockwise to „ “. Press knob and hold for 3 minutes before attempting
ignition.
Summary of Contents for 825131
Page 2: ......
