EN
page 27
INSTALLER SECTION
To adjust the capacity of the pump, use a screwdriver (see image 3).
THE DISPENSERS ARE PRE-SET TO A 1,65 gr INTAKE OF PRODUCT FOLLOWING A
TEST PHASE SYSTEM CHECK. THIS MEASUREMENT SHOULD BE ADJUSTED AC-
CORDING TO THE TYPE OF RINSE AID USED AND WATER HARDNESS.
1.7
Optional programmation
A) D
i
p switch
Thanks to the
d
i
p switch
you can enable or disable the following functions, according to
how the machine is equipped (see image 4):
1) Water softener
2) Drain pump
3) Cold fi nal rinse
4) Cycle start at door closing.
B) Setting of the hardness level of the feeding water
The setting of the board allows to insert the hardness level of the feeding water, in order to
inform users about the need to regenerate the resins of the water softener.
This function will be activated only if the D
i
p Switch
1
is on ON mode
The electronic board is set, as default, on a medium average level of hardness.
Setting:
when the machine is ON, the softener LED
E
(see chap.
4
) will start to fl ash quickly,
after pushing for 5 seconds, simultaneously, both Softener button
L
(see chap.
4
) and START
B
(see chap.
4
) button. This means that you can now start setting the machine.
By the START button
B
(see chap.
4
) it will now be possible to select the level of hardness
of the feeding water by keeping pushed the START button
B
(see chap.
4
).
LED
P
lighted on – LOW: Water hardness from 10° to 15° F = 80 rinsing cycles, before
regenerating.
LED
O
lighted on – MEDIUM: Water hardness from 15° to 25° F = 50 rinsing cycles, before
regenerating.
LED
N
lighted on – HIGH: Water hardness from 25° to 35° F = 35 rinsing cycles, before
regenerating.
Push the softener button
L
(see chap.
4
) to memorize the selected level.
The board will memorize all rinsing cycles even if main power switch is switched OFF. Once
the machine reached the quantity of rinsing cycles foreseen by the water-hardness function,
will inform user by fl ashing (yellow) of LED
E
(see chap.
4
).
User can start a softener/ regeneration cycle.
At the end of the regeneration cycle the counter will automatically reset to zero.
The LED
D
(see chap.
4
) will light only when the salt in the container will be at low level.
OFF
1
2
3
4
ON
OFF
ON
1
2
3
4
Default setting
OFF
ON
cod. 15985/G
fi g. 3
15186/T
image 4
Summary of Contents for 110555
Page 6: ...EN page 24 ...
