EN
page 34
USER SECTION
In the case of water hardness above 35°f it is advisable to install an exter-
nal water softener.
5.6
H.A.C.C.P. and hygiene regulations
• The machines are equipped with a temperature indicator (led
Q
- chap.
4
) which lights
up when the boiler and the tub have reached the preset temperature (values set by the
manufacturer). It is recommended to wait for this light to go on before starting the next
cycle.
• Scrape food from the dishes carefully in order not to clog the fi lters, nozzles and pipes.
• Unload the wash tub and clean the fi lters at least twice a day.
• Check that the amount of detergent and rinse aid dispensed is correct (as suggested by
the supplier of the product). In the morning before starting up the machine, check that
there is enough product in the containers for daily use.
• Always clean the support fl oor of the dishes.
• Remove the rack from the dishwasher with clean hands or gloves so as not to dirty the
cutlery.
• Do not dry or polish the dishes with non-sterilized cloths, brushes, or dusters.
6. MAINTENANCE
6.1
Routine maintenance
WARNING: The machine is not protected against pressurized water jets. Do not use
pressure cleaning system against the machine.
It is recommended to contact seller for cleaning instructions, in order to have detailed
indications on methods and products for the correct periodical machine sanitation.
Do not use bleach or chlorine based detergents.
Daily cleaning is needed to ensure that the machine runs perfectly. The following shall be
carried out:
• Turn the machine in stand-by mode, by pressing the push-button
M
of the control panel
(see chap.
4
).
• Drain the water by removing the overfl ow pipe. For appliances provided with emptying
pump follow the indications as described on paragraph
5.4.
• Remove the fi lters and chutes and clean with a brush and a water shower.
• Remove the arms by loosening the fi xing screws, and thoroughly clean them, and the
nozzles under running water.
If presents, remove the surface fi lters and clean it with a brush under running water (see
image 14).
• Reassemble all parts and refi t the rotors in their seats, fi xing them with the relative screws.
Take extreme care to re-assemble the nozzles in the right position (open and / or closed
nozzles) and that the arms are installed with the right axial angle.
• Clean the tank very carefully, using a water shower.
• Automatic cycle of machine self-cleaning/ rinsing:
The machine should be in stand-by mode (red-lighted LED
C
- see chap.
4
), remove
the overfl ow pipe and close the door. Push START button
B
(see chap.
4
) hold it for 5
seconds. An automatic cycle of 15 seconds will start, after this the machine will be in
stand-by mode.
• Shut the water valve.
• Turned off the machine by switching the main power switch OFF.
N.B.: It is recommended to change the water in the wash-tank at least every
20 wash cycles, or twice a day. Do not use metal-wool for cleaning and/or
corrosive products, which will damage the machine.
!
image 14
!
Summary of Contents for 110555
Page 6: ...EN page 24 ...
