Bartscher 104.805A, Operating Manual

Page: 34 / 90

E E N N
8. remove top of appliance by lifting rear part and releasing it from front hooks (Fig. 18). NOTE: on some models the top is secured to
the rear panel of the appliance with a screw, which must be removed before lifting the top and repositioned when cleaning and
sanitizing operations are finished
9. remove evaporator cover panel (Fig. 19) and clean top part of evaporator, bin, evaporator cover panel and door with water and
vinegar solution
10. remove any sediment from evaporator and evaporator cover panel using a brush with soft bristles and a non-abrasive sponge
11. pour plenty of cold water onto the evaporator and with the aid of the brush, direct the sediment removed into the basin beneath, taking
care not to obstruct the holes in the base of the evaporator.
During cleaning of evaporator, take care:
• not to bend coils
• not to detach water supply pipes
• not to remove evaporator thermostat
12. remove (Fig. 15) and clean with ordinary washing-up liquid:
• flag support assembly (1)
• ice-cube slide (2)
• overflow pipe (3)
• sprayer bank (4), taking care to remove side caps (5)
• sprayer bank feed pipe (6)
• pump filter (7)
13. clean with the same washing-up liquid:
• evaporator cover panel
• inner basin
• bin
• door
14. thoroughly rinse previously cleaned parts with cold water
15. rinse and refit (Fig. 15):
• pump filter (7)
• sprayer bank feed pipe (6)
• sprayer bank (4), after repositioning side caps (5)
• overflow pipe (3)
• evaporator cover panel (Fig. 5)
16. prepare to perform the sanitizing operations described in the next chapter
11 SANITIZING
Use a 200 mg/l solution of sodium hypochlorite and water (or a solution of ½ ounce of normal bleach to 1 gallon of water) or one of the
solutions commonly used to disinfect babies’ feeding bottles; in this case, check that the sanitizing product is:
• authorized by your country’s Ministry of Health
• suitable for use with food machines
• not harmful to the materials and components of this appliance
For the directions for use and concentrations, please refer to those shown on the packaging and recommended by the manufacturer. We
recommend using the solution at the temperature of 25°C.
1.
fill basin with sanitizing solution. Refer to the table for the amount of solution required, depending on daily production (Fig. 2)
2. refit ice-cube slide (2 in Fig. 1) and flag support assembly (1 in Fig. 15)
Before connecting the appliance to the mains electricity supply, ensure that all cables and electrical wiring are perfectly
dry.
3. operate ice maker for five one-minute periods, with a five-minute break between them
IMPORTANT: The pump must be in operation during sanitizing cycles (check that water is sprayed). If it is not, immediately
adjust timer regulation screw by turning it clockwise until the indicator on the pin exits from the zone marked DEFROST.
To reach timer, loosen screws in front panel with a Phillips screwdriver, remove front panel by pulling it upwards, and regulate timer with a
flat-head screwdriver (Fig. 17).
4.
switch off machine and disconnect it from the mains electricity and water supply
5. remove evaporator cover panel (Fig. 19)
6. pour sanitizing solution onto top part of evaporator, distribute with a brush, and rinse thoroughly with cold water
7. remove (Fig. 1) and immerse in sanitizing solution for 30 minutes:
• flag support assembly (1)
• ice-cube slide (2)
• overflow pipe (3)
• sprayer bank (4) and side caps (5), after removing them from the bank
• sprayer bank feed pipe (6)
• pump filter (7)
• evaporator cover panel (Fig. 19)
8. wipe container walls and door with sanitizing solution using a sponge and brush