SG10
OIPB – B19053
OWNER’S MANUAL
17
V-Belt Alignment and Tensioning
Remove the bolts that secure the V-belt cover to the saw frame.
Check uniform parallelism of V-belt and pulley (sheaves). Use a straight-edge or machinist’s
square against both pulleys and adjust both pulleys until equally aligned.
Do not over or under tighten the V-belt. Severe damage can occur to the saw and engine crank
shaft if the belt is over-tensioned. A decrease of power to the blade and poor performance will
result if the belt is under-tensioned (loose on pulleys).
Discount-Equipment.com
