SG10
OIPB – B19053
OWNER’S MANUAL
14
Operation
1. Ensure the engine Shutdown switch and the engines ON/OFF switch on the engine are
both in the OFF position to avoid accidental starting.
2. Place the fuel valve lever to the “ON “Position.
3. Place the engine Shutdown switch and the engine ON/OFF switch on the engine to the
“ON Position”.
4. Place the Choke Lever in the “CLOSED” position.
5. Rotate the throttle lever halfway between Fast and Slow for starting. All sawing is done
at full throttle. The engine governor speed is factory set to ensure optimum blade
operating speeds.
6. Grasp the starter grip and slowly pull it out. The resistant becomes the hardest at a
certain position, corresponding to the compression point. Pull the starter grip briskly and
smoothly for starting.
7. If the engine has started, slowly return the choke lever to the “OPEN” position. If the
engine has not started repeat steps 1 through 5.
8. Before the saw is placed into operation, run the engine for several minutes. Check for
fuel leaks, and noises that would associate with a loose guard and/or covers.
9. Rotate the throttle lever toward full throttle.
10.
To begin sawing, lower the rotating blade by turning the wheel clockwise and allowing it
to cut to the desired depth.
11.
When blade has reached full cutting depth, slowly walk behind the saw at a rate that will
allow the engine to operate without losing optimum RPM.
12.
When the end of the cut has been reached, raise the blade out of the cut by turning the
wheel counter clockwise.
13.
If cutting is complete, shut the saw down using the following “Shutdown Procedures”
(Section 3.2).
Discount-Equipment.com