SG10
OIPB – B19053
OWNER’S MANUAL
16
Maintenance SG10
Blade Removal and Replacement
1. Ensure the Engine Shutdown switch and ON/OFF switch on the engine are turned to the
“OFF position”.
2. Place the SG10 Saw on a stable level working surface.
3. Ensure the blade is raised and the raise/lower rod is locked into position.
4. Raise the blade by applying a downward pressure on the handlebars to raise the blade
and allow the raise/lower rod to drop into the “raised-position” slot.
5. Lift the blade guard cover to gain access to the diamond blade.
6. Use the provided blade nut and blade shaft locking wrenches to install the diamond
blade.
7. While holding the blade shaft with the locking wrench, remove the blade hex nut
(clockwise direction) and outer blade flange.
8. Remove the old blade and install a new blade in the same rotational direction as marked
on the blade.
9. Reinstall the outer blade flange and hex nut. Tighten the nut firmly (counter-clockwise
direction).
Do not overtighten
.
Blade Guard Check
1. Check the following on the “blade guard”: Ensure the capacity of the blade guard
matches the diameter of your diamond blade.
2. Check that the guard is bolted firmly upon the saw frame.
3. Check that the spring tensioned front cover of the guard is firmly seated with the rear
section of the guard, and there are no gaps.
Never
lift the blade guard while cutting.
Discount-Equipment.com