CONCRETE SAW INSTRUCTION MANUAL
BARTELL MORRISON INC.
BARTELL MORRISON (USA) LLC
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
12 INDUSTRIAL DRIVE, KEYPORT, NEW JERSEY, USA, 07735, 732-566-5400 FAX 732-5444
Created: 12/08
Revised: 12/10
Remove the Blade Guard Assembly (36), and re-install on the other side of the Concrete
5.
Saw.
(See Figure B)
Re-install the Shaft Cover Assembly (33) on the side of the unit.
6.
(See Figure B)
Make sure the Water Hose (29) is kept clear of hot and moving parts of the Concrete
7.
Saw.
(See Figure B)
OPERATING INSTRUCTIONS
IMPORTANT! Your Warranty is voided if:
1.
You do not put engine oil in the Engine’s crankcase prior to its first use.
Before
each use, check the oil level. Never run the Engine with low or no engine oil. Running
the Engine with low or no Engine oil will permanently damage the Engine.
Make sure the Engine (30) of the Concrete Saw if filled with the proper amount
2.
of oil and unleaded gasoline recommended by the Engine manufacturer before
attempting to start the Engine.
Failure to do so WILL damage the Engine and void the
warranty.
(See Engine manufacturer’s instruction manual)
Check to make sure the V-Belts (35) are properly tensioned.
3.
(See page 11 of this
manual)
At any time the Concrete Saw is being transported, the Saw Guide (21) must be in its
locked (upward) position and the Pointer (24) in its downward position.
(See Figure C)
