CONCRETE SAW INSTRUCTION MANUAL
BARTELL MORRISON INC.
BARTELL MORRISON (USA) LLC
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
12 INDUSTRIAL DRIVE, KEYPORT, NEW JERSEY, USA, 07735, 732-566-5400 FAX 732-5444
Created: 12/08
Revised: 12/10
ASSEMBLY INSTRUCTIONS
Disconnect the Spark Plug Wire from the Engine of the Concrete Saw.
1.
To install a Saw Blade (not included) on the
2.
RIGHT SIDE
of the Concrete Saw, make
sure the Blade Shaft (8), Inner Blade Collar (10), and Outer Blade Collar (11) are clean
and free of dirt and debris.
(See Figure A, next page and Figure C, page 9)
Remove the Hex Bolt (48) and Outer Blade Collar (11).
3.
(See Figure A)
Install the Saw Blade onto the Blade Shaft (8).
4.
Make sure the arrow depicted on the
Saw Blade points in the same direction as the arrow depicted on the Blade Guard
Assembly (36). (See Figure A)
Replace the Outer Blade Collar (11).
5.
Make sure the Offset Drive Pins on the Inner
Blade Collar (10) and Outer Blade Collar line up with the corresponding holes in
the Saw Blade. (See Figure A)
Firmly tighten the Hex Bolt (48) back into the Blade Shaft (8).
6.
(See Figure A)
TO INSTALL THE SAW BLADE
ON THE LEFT SIDE OF THE CONCRETE SAW
The Saw Blade may be installed on either the right or left side of the Concrete Saw.
1.
To do so, remove the Shaft Cover Assembly (33).
2.
(See Figure B, next page)
Remove the Hex Bolt (48), Outer Blade Collar (11), Saw Blade, and Inner Blade Collar
3.
(10).
(See Figure A, this page)
Re-install the Inner Blade Collar (10), Saw Blade, Outer Blade Collar (11), and Hex Bolt
4.
(48) on the Blade Shaft (8) located on the other side of the Concrete Saw.
(See Figure
A)
