RDG603A63 - Issue 10
Page 67 of 104
5. Cylinder Head Tightening Sequence
Figure 31: Cylinder Head Tightening Sequence
•
Tighten all the cylinder head bolts to 30Nm following the sequence shown in
•
Tighten all the cylinder head bolts to 50Nm following the sequence shown in
•
Put a paint mark on each bolt as reference point.
•
Turn all the cylinder head bolts 60° clockwise following the sequence shown in
•
Turn all the cylinder head bolts a further 60° clockwise following the sequence shown
The bolts can only be reused a MAXIMUM of two times
6. Fuel Injection Pump
If the fuel injection pump is removed and replaced for any reason, please be aware that there
is no key or master spline on the injection pump drive shaft. To achieve the correct injection
pump timing either look at the Stanadyne website or follow the instructions below:
