Wall Mount
1. Remove the lens cover by loosening the (4) #8-32 x 3/8” screws (A) and
set aside. (Fig. 1)
2. Remove the housing by loosening the (2) #8-32 x 1/4“ screws (B) and set
aside.
3. Remove the battery by loosening the velcro strap. (Fig. 2)
4a.
Wall Mount
- Remove the center knockout and any desired knockouts for
mounting to the J-box located in the backplate and the corresponding
knockouts on the supplied gasket. Apply the gasket to the back of the
backplate, as shown. Mount the backplate assembly to the J-box.
4b.
Wall Mount with conduit
- Remove the desired knockouts on the
backplate and the corresponding knockouts on the supplied gasket. Apply
the gasket to the back of the backplate, as shown. Mount the backplate
assembly to the wall using appropriate hardware for the mounting surface.
Remove the conduit access plug and install a 1/2” NPT liquid-tight fitting
(not provided).
5. For additional mounting support, remove additional knockouts and use
appropriate hardware for mounting surface. (Fig. 3)
6. All electrical connections should be made inside the
junction box.
Make electrical connections as follows:
120VAC
277VAC
White - Common
White - Common
Black - 120VAC
Orange - 277VAC
Green - Ground
Green - Ground
Note:
Cap unused leads to prevent shorting.
7. Secure the battery using the velcro strap.
8. Secure the housing using the (2) #8-32 x 1/4“
screws from
before.
9. Secure the lens cover using the (4) #8-32 x 3/8”
screws
from before.
10. To weatherproof your fixture, be sure to seal all holes in
the housing (mounting, conduit, plugs, etc.) with silicone
sealant. Apply sealant across the top edge to prevent
water from reaching the back of the housing.
Lens Cover
Housing
Fig. 1
(A) x4
#8-32 x 3/8”
(B) x2
#8-32 x 1/4”
Battery
Velcro
Strap
Knockout
Conduit Access Plug
Fig. 2
White (Common)
Black (120V)
Orange (277V)
Green
(Ground)
Transformer
Fig. 3
Gasket
Backplate
Backplate
CP-EMW Series
Installation Instructions
10070140
R
EV 5 - 02/21
2
800-533-3948 www.barronltg.com
