Baroness LM315GC, Service Manual

Page: 162 / 199

Mower Mounting Bracket
The mower mounting brackets may be bent due
to frequent use, damage during transportation,
etc.
Inspect it, and if necessary, replace the parts.
Make sure that the mower mounting
brackets are not bent nor damaged.
Make sure that there is no wear nor rust of
the roller shaft receiver.
Make sure that there is no damage to the
spring.
Make sure that there is no play in the fit of
the ball joint and ball joint holder.
Caution
See the list in " "Tightening torques" (Page
3-6) ".
Note that the Baroness product warranty may
not apply to defects caused by incorrect
tightening etc.
Remove the mower mounting bracket Assy.
Remove the cotter pin, stopper, spring, and
cap bolt.
3
2
4
1
c8te81-001
Mower Mounting Bracket_001
1 Cotter pin
2 Stopper
3 Spring
4 Cap bolt
･
･
･
･
1.
2.
Loosen the nut and remove the ball joint
holder.
1
2
c8te81-002
Mower Mounting Bracket_002
1 Nut
2 Ball joint holder
Follow the steps below to install the mower
mounting bracket.
Adjust it so that the distance between the
center of the roller shaft receiver of the
mower mounting bracket and the end of
the ball joing holder becomes 100.0 mm
(3.94 in).
Tighten the nut with the larger notch of the
ball joint holder facing downward.
2
1
100.0 mm
(3.94 in)
c8te81-003
Mower Mounting Bracket_003
1 Mower Mounting Bracket
2 Notch
3.
4.
[1]
[2]
LM315GC
Operating Machine and Mower Units
Page 7-44 Inspection and repair of each section