−5−
[2]Be careful durig adjustment of the machine to prevent entrapment of the fingers
between moving blades and fixed parts of the machine.
20.On multi-cylinder/multi-reel machines take care as rotating one cylinder/reel can cause
other cylinder/reels to rotate.
21.Keep hands and feet away from moving parts. If possible, do not make adjustments with
the engine running.
22.Charge batteries in an open well ventilated area, away from spark and flames. Unplug
charger before connecting or disconnecting from battery. Wear protective clothing and
use insulated tools.
23.Keep all parts in good working condition and all hardware tightened. Replace all worn or
damaged decals.
24.Keep all nuts, bolts and screws tight to be sure the equipment is in safe working
condition.
25.Check the grass catcher frequently for wear or deterioration.
26.If the fuel tank has to be drained, do this outdoors.
About the waste disposal
Make sure that waste generated when servicing or repairing the machine is disposed of in
accordance with local regulations.
(e.g. waste oil, antifreeze batteries, rubber products, and wires etc.)
Long-term storage
●
Please refer to the Engine/Battery operation manuals for details.
1. Clean up dirt, grass and oil spot etc.
2. Inspect and replace the engine oil and air filter element.
3. Refill oil and apply lubricating/greasing to each lubrication part.
4. Empty the fuel tank and keep the mower away from ignition sources when storing the
mower indoors where sparks and open flames are used.
5. Set the air pressure in the tires slightly higher than normal, place the machine on a
board to avoid humidity.
6. Inspect all bolts, nuts and screws tightened. If loose or missing, tighten or repair them.
7. Repair or replace damaged parts and paint peelings.
8. Store the machine in the place where is dry and prevent exposure to rain.
9. Remove the battery and ignition key from the mower. If you keep the battery installed in
the machine, disconnect the ground battery cable (negative side).
10. When storing the machine, lower the cutting units. In case to store the machine with
raising the outermost #4 & #5 mowers, be sure to latch them.
