Baroness LM18GB, Owner'S Operating Manual

Page: 27 / 81

Installing the Stand
With the inside projection side set to the
right, temporarily secure the left side of the
stand to the frame with the bolt, washer
(inside), and nut (outside).
Put the spring on the projection of the frame
and the projection at the right edge of the
stand.
1
5
6
3
2
4
y7fthb-001
Installing the Stand_001
1 Stand
2 Bolt
3 Washer
4 Nut
5 Projection
6 Spring
While pulling the right side of the stand
backward, make alignment with the hole in
the frame, and secure the stand with the
bolt, washer (inside), and nut (outside).
Tighten the bolt, washer, and nut at the left
side of the stand that were temporarily
secured.
Step:4
Step:3
1
4
2 3
y7fthb-002
Installing the Stand_002
1 Stand
2 Bolt
3 Washer
4 Nut
1.
2.
3.
4.
Confirmation of the Operation
Check that the brake operates completely.
Check that the engine clutch operates
completely.
If necessary, make adjustment.
Inspection Before Use
Be sure to perform an inspection before you
start using the machine so that you will be able
to take advantage of its optimum performance
for a long period of time.
Reel Cutter (Cutting Cylinder) and Bed
Knife (Bottom Blade)
Inspection of Reel Cutter (Cutting Cylinder) and
Bed Knife (Bottom Blade)
The reel cutter (cutting cylinder) and bed knife
(bottom blade) may become dull due to
frequent use, objects crushed during mowing,
or damage caused during transportation.
Inspect the reel cutter (cutting cylinder) and
bed knife (bottom blade), and if necessary,
adjust the blade engagement, perform back
lapping, or resharpen or replace the reel
cutter (cutting cylinder) and the bed knife
(bottom blade).
Check to see whether or not the edge of
the reel cutter (cutting cylinder) and the bed
knife (bottom blade) are too blunt to cut.
Make sure that the reel cutter (cutting
cylinder) and the bed knife (bottom blade)
are not cracked.
Check to see how much the reel cutter
(cutting cylinder) and the bed knife (bottom
blade) are worn.
Make sure that the reel cutter (cutting
cylinder) and the bed knife (bottom blade)
have not changed color due to heat from
grinding.
Check to see whether or not the second
edge face remains at the point of reel cutter
(cutting cylinder).
Make sure that the welding between the
reel cutter (cutting cylinder) and the disc
has not come off.
1.
2.
3.
1.
2.
3.
4.
5.
6.
Handling Instructions
LM18GB
・
LM56GB/LM66TB
Handling Instructions
Page 5-3
Inspection Before Use