20
20
21
Equipped with the groomer
1) Apply the grease (EXCELITE EP No.2) to the 20-tooth
reel gear [8-46].
Apply the grease also to the vertical gear case’s O-ring
[8-48].
(Make sure that the O-ring is firmly fitted into the groove.)
2) Fit the vertical gear case over the 20-tooth reel gear
[8-46]. (Push the case in the direction of as far as
possible.)
On the opposite side, fit the left vertical housing [8-63]
into the frame’s groove, and raise the groomer.
3) Insert the right and left square-root bolts [8-49] along
the groove from the inside of the frame.
Insert the adjusting screw 108 [8-57] and secure it
temporarily with the spring washer [8-59] and tall nut
[8-58].
4) Attach the right case locking bolt [8-60]. (This bolt is for
keeping the case from unfastening, not for locking it
down.)
* Be careful not to tighten the bolt too hard.
5) Tighten the tall nut [8-58] on the adjusting screw on
both sides.
O-ring
Vertical gear
case
Groomer
Square-root
bolt
Tall nut
Square-root
bolt
Left vertical housing
Adjusting screw
1.6 compression spring
13.720
2C5191P washer 8.522
Right case locking bolt
6S washer
6 bolt 10
Clutch retainer
spring 5
H/L change lever
8) Install the H/L change lever [6-91] on the left cover
[6-89], attach the clutch retainer spring 5 [6-56], 6S
washer, 6 bolt 10.
* Install the alignment finger of H/L change lever in the
33-tooth reel gear and 42-tooth reel gear.
