14
14
15
11) Insert the spline side of the reel cutter into the left
frame [6-43].
* Be careful not to damage the oil seal.
12) Set up the reel cutter by reversing the steps to remove it.
* Please refer to pages 12-12).
(Install the right reel housing on the right frame.)
13) Set the right reel housingÅfs grease nipple at the notch
of the frame, and secure it using the three hexagon
socket head counter sunk bolts [1-37].
14) Install the tapered roller bearings [1-36] to the reel cut-
ter and make sure the tapered side faces in.
15) Install the left bearing collar [1-43] to the reel shaft,
and, after matching the holes on the collar and shaft,
insert the needle roller [1-45] into the holes. Install the
pin lock cover [1-44], and the O-ring P18 [1-33], and
install the 33-tooth reel gear and 42-tooth reel gear
[1-46], 36-tooth reel gear and 45-tooth reel gear [6-54]
while marking sure the direction of the gear is small
side out.
Reel cutter
(spline side)
8 hexagonal socket head flush bolt 20 Nipple
Tapered roller bearing
Tapered roller bearing
O-ring P18
Left bearing collar
Pin lock cover
Needle roller