Follow the same steps to adjust the groomer
operating height on the opposite side.
Firmly tighten nuts B and nuts C.
Tighten nuts A of the groomer adjustment
screws.
Again, make sure that the groomer operating
height is set at the required position by
positioning the cutting height gauge against
the front roller and rear roller at the edge on
the left and right sides of the mower unit.
Note:
If the groomer is not used, raise the groomer.
Adjustment of CR brush
Adjustment of CR Brush (CR Brush Only
Installation)
Note:
Depending on the specifications, this function
may not be available.
Important
If the contact between the brush and rear
roller is too tight, the belt may slip or break.
Important
The rotating CR brush prevents grass
clippings, etc., from attaching to the rear roller.
Loosen bolt A.
Loosen the left and right bolts B.
Adjust the CR brush so that there is a
clearance of 0 to 1.0 mm (0 to 0.039 in)
between it and the rear roller, and then
firmly tighten loosened bolt A and bolts B.
1
3
4
2
zp6tso-005
Adjustment of CR Brush (CR Brush Only Installation)_001
1
Brush
2
Rear roller
3
Bolt A
4
Bolt B
6.
7.
8.
9.
1.
2.
3.
Adjustment of CR Brush (installed together with
Groomer)
Note:
Depending on the specifications, this function
may not be available.
Important
If the contact between the brush and rear
roller is too tight, the belt may slip or break.
Important
The rotating CR brush prevents grass
clippings, etc., from attaching to the rear roller.
Loosen the left and right bolts.
Adjust the CR brush so that there is a
clearance of 0 to 1.0 mm (0 to 0.039 in)
between it and the rear roller, and then
firmly tighten the bolts.
1
3
2
zp6tso-006
Adjustment of CR Brush (installed together with
Groomer)_001
1
Brush
2
Rear roller
3
Bolt
1.
2.
LH52
Handling Instructions
Page 4-12
Adjustment Before Operating
