Position the left and right roller brackets in
the orientation and at the installation holes
for the desired cutting height, and then
install them.
Install the rear roller.
Adjustment of Front Roller
Important
For adjustment, be sure to use the cutting
height gauge so that the right and left sides
can be parallel.
Attach the rear roller within the cutting
height range at a position that suits your
work requirements.
Set the slide caliper to the required cutting
height, adjust the position of the bottom of
the head of the small screw for cutting
height setup in the cutting height gauge,
and then securely lock it with a fly nut.
3
1
2
3kws2a-028
Adjustment of Front Roller_001
1
Cutting height gauge
2
Small screw for groomer setup
3
Small screw for cutting height setup
Loosen the nuts of the left and right front
roller brackets.
Position the cutting height gauge against
the front roller and rear roller at the edge on
the left and right sides of the mower unit.
Adjust the cutting height with the left and
right cutting height bolts on the front roller
brackets.
To increase the cutting height:
Turn the cutting height bolt in direction A
to lower the front roller.
2.
3.
1.
2.
3.
4.
5.
･
To decrease the cutting height:
Turn the cutting height bolt in direction B
to raise the front roller.
3
B
A
5
1
4
7
2
6
8
9
3kws2a-029
Adjustment of Front Roller_002
1
Front roller bracket
2
Nut
3
Cutting height bolt
4
Front roller
5
Rear roller
6
Reel cutter (Cutting cylinder)
7
Bed knife (bottom blade)
8
Cutting height gauge
9
Small screw for cutting height setup
Move the front roller up or down with the
cutting height bolt to position the front roller
so that there is no gap between the cutting
edge and the small screw for cutting height
setup in the cutting height gauge at the left
and right edges of the bed knife (bottom
blade).
3
A
2
1
3kws2a-007
Adjustment of Front Roller_003
1
Bed knife (bottom blade)
2
Small screw for cutting height setup
3
Cutting height gauge
A
Cutting height
Follow the same steps to adjust the cutting
height on the opposite side.
･
6.
7.
Handling Instructions
LH52
Handling Instructions
Page 4-9
Adjustment Before Operating
