Adjustment of Groomer
Note:
Depending on the specifications, this function
may not be available.
Important
For adjustment, be sure to use the cutting
height gauge so that the right and left sides
can be parallel.
Important
Set the grooming height more than 5.0 mm
(0.2 in) from the ground.
If it is set lower, the groomer shaft, bearings,
gears, etc., may be damaged.
Adjust the cutting height according to the
grooming work.
Set the small screw for groomer setup of the
cutting height gauge to the desired height.
3
1
2
3kws2a-028
Adjustment of Groomer_001
1
Cutting height gauge
2
Small screw for groomer setup
3
Small screw for cutting height setup
Loosen nuts A of the left and right groomer
adjustment screws.
Loosen the left and right nuts B and nuts C.
1.
2.
3.
Position the cutting height gauge against the
front roller and rear roller at the edge on the
left and right sides of the mower unit.
3
4
1
6
5
2
7
9
8
10
2qrq2r-009
Adjustment of Groomer_002
1
Groomer adjustment screw
2
Nut A
3
Nut B
4
Nut C
5
Front roller
6
Rear roller
7
Dethatching blade
8
Reel cutter (Cutting cylinder)
9
Bed knife (bottom blade)
10
Cutting height gauge
Important
Adjust so that the small screw for groomer
setup contacts the dethatching blades.
1
4
3
2
A
2qrq2r-002
Adjustment of Groomer_003
1
Dethatching blade
2
Small screw for groomer setup
3
Cutting height gauge
4
Front roller
A
Operating height
Adjust nuts C up or down so that the left and
right sides are parallel.
4.
5.
Handling Instructions
LH52
Handling Instructions
Page 4-11
Adjustment Before Operating
