Barnes thermoplay TH-M6, User Manual

Page: 50 / 71

50
Table 10 : common parameters, highlighted in grey if read-only even with “Administrator” level of access.
Idx Parameter
D
ec
. d
ig
its
M.U.
Min
Value Max
Value Default
Value
0 Cycle time
(if changed, the new value will be active at the next system
start up)
1 sec 0.5 10.0 2.0
1 % SP end Soft Start - start Auto Tuning 0 % 1 100 25
2 SP1/SP2 selection 0 0=SP1 1=SP2 0
4 Baud Rate - 38400 38400 38400
5 Synchronous heating tolerance 0 °C 0=off 100 10
6 Band outside of that fuoc value is idx 7
(if the ramp is active)
1 °C 0 9999 30.0
7 Fuoc value outside of band (referring to parameter idx=6) 1 - 0.1 10.0 1.0
8 K_TAU for Auto Tuning calculation 1 - 0.1 100.0 20.0
9 K_FPB for Auto Tuning calculation 1 - 0.1 100.0 4.0
10 Cpb, corrective factor for proportional band 1 - 0.1 100.0 1.5
11 Drying time 0 sec 0 999 900
12 Drying voltage 0 Volt 60 190 160
13 Proportional Band under Auto Tuning temperature 1 °C 0 199.9 1.0
14 Integral time under Auto Tuning temperature 0 sec 0 999 0
15 Derivative time under Auto Tuning temperature 0 sec 0 999 0
16 Temperature threshold to abort Soft Start 0 °C 0 999 80
17 Digital filter for displayed temperature 1 °C 0.0 10.0 2.0
18 OUTPUT 1 (enabling signal) logical level - - 0:open=OK 1:close=OK 1
19 OUTPUT 2 (alarm signal) logical level 0:open=Fail
2:open=Fail
1:close=Fail
3:close=Fail
3
20 WAIT Output enabled (OUTPUT 3) 0: not active 1:active 1
21 Logical level OUTPUT 4 (used for fans)
22 INPUT 1 (switch to SP2) logical level 0:open=SP2 1:close=SP2 1
23 INPUT 2 (switch to “OFF” all the zones) logical level 0:open=OFF 1:close=OFF 1
24 Logical level INPUT 3 (not used)
25 Hold band for wait after end of Auto Tuning 0 °C 0 100 15
26 Validate band of temperature around SP (LEAKAGE ALARM) 1 °C 0 999.9 5.0
27 Delay after Set Point is reached for power calculation
(LEAKAGE ALARM)
0 sec 30 7200 900
28 Time for average power calculation (LEAKAGE ALARM) 0 sec 30 7200 300
29 Relative power % increasing to get the LEAKAGE ALARM 0 % 0 100 50
30 Digital output delay 0 min 0 1000 1
31 Set Point change band for LEAKAGE ALARM power
recalculation
0 °C 0 100 15