Barko 830B, Service Manual

Page: 143 / 218

60-9
®
SERVICE- DURST 2PD PUMP DRIVES
2PD06, 2PD08, 2PD10
2PD PUMP DRIVE IDENTIFICATION & SPECIAL TORQUES
535-07768 2PD06 1:1 830B
535-07575 2PD06 1:1 930B
***not all BARKO Durst Pump Drive configurations listed above***
535-06822 2PD06 1.32I 920
535-07598 2PD08 1:1 937B
535-07578 2PD08 1.13I 937B
535-06741 2PD06 1.57I 695
535-06748 2PD06 1.06I 695
BARKO P/N Pump Drive Barko Application
535-06171 2PD06 1:1 930
BARKO Machine Applications for DURST PUMP DRIVES:
535-06636 2PD06 1.57I 920
1. GENERAL PUMP DRIVE INSTALLATION
NOTICE
There are 3 types of standard inputs that are available with the Durst
pump drive models. Check with BARKO Service for which is applicable for
your BARKO machine.
1.1 Drive Plate Driven
This unit mounts directly to the engine flywheel. Use extreme care when mounting the drive plate to
the engine flywheel to avoid pre-loading the crankshaft bearings.
1.
2.
3.
Bolt the drive plate to the engine flywheel, see (see Table-1) for proper torque specifications
Install the drive plate onto the engine flywheel, drive plate hub is to face AWAY from the engine.
when tightening bolts.
Check drive plate run out. Total TIR should not exceed 0.008".
Apply Silver Streak #200S to external splines and slide the input shaft of the pump drive into the
drive plate hub splines until the pump drive engine adapter seats completely into the engine
flywheel housing. Torque all mounting bolts per (see Table-1) .
3/8-16 30 ft-lbs 45 ft-lbs
7/16-14 50 ft-lbs 70 ft-lbs
3/4-10 270 ft-lbs 375 ft-lbs
5/8-11 150 ft-lbs 210 ft-lbs
Fill, Drain & Vent Plugs: 50 ft-lbs
1/2-13 75 ft-lbs 105 ft-lbs
BOLT & PLUG TORQUES
Size Gr. 5 Gr. 8
Table-1
06/05/2019
Updated
SERVICE