Bard Sherlock 3CG TCS, Instructions For Use Manual, Page: 25 / 28

23
Sherlock 3CG™ Tip Confirmation System
Magnetic navigation Stylet icon
has erratic behavior
Magnetic navigation Stylet icon
disappears, "sweeping magnifying glass"
displayed.
If problems continue, call the technical support hotline at (800) 443-3385.
7 Magnetic Navigation Printing
Select the 'F6' key on the keyboard [ ] to open Settings.
- Under the menu, navigate down until the MAGNET PRINTOUT DISABLED [ ] button is highlighted.
- Select the MAGNET PRINTOUT DISABLED [ ] button
- After being selected the MAGNET PRINTOUT DISABLED button will toggle to the MAGNET PRINTOUT ENABLED [ ] button.
- Close Settings by selecting the EXIT [ ] button.
Note: Selecting [ ] after Magnet Navigation Only Mode will send the procedural record to a storage device and/or an approved printer, if connected.
A typical Magnet Navigation Only printout is shown below.
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Stylet at edge of sensor’s depth range (3 to 11 cm).
1. Pull catheter back until stylet icon is stable.
2. Verify catheter is moving in the correct direction and continue placement.
Magnetic interference.
Pull catheter tip back at least 12 inches (30 cm) from the sensor, recalibrate,
and re-advance catheter.
Too much time has passed since calibration. Magnetic fields have changed.
Pull catheter tip back at least 12 inches (30 cm) from the sensor, recalibrate
and re-advance catheter.
Stylet is out of sensor’s depth range (3 to 11 cm).
1. Pull catheter back until stylet icon is stable.
2. Verify catheter is moving in the correct direction and continue placement using
ECG guidance and catheter measurement.
Magnetic interference.
Pull catheter tip back at least 12 inches (30 cm) from the sensor, recalibrate, and
re-advance catheter.
Too much time has passed since calibration. Magnetic fields have changed.
Pull catheter tip back at least 12 inches (30 cm) from the sensor, recalibrate and
re-advance catheter.