7. Advanced operations
Image 7-59
7.9.5
3D emitter Setup
Why change the 3D setup?
While Barco provides a 3D emitter and active shutter glasses as options to this projector, you are free to use a 3D emitter and active
shutter glasses of your own choice. Since glasses and emitter can have various speci
fi
cations compared to the ones Barco provides,
the 3D setup menu allows you to con
fi
gure the output image to the speci
fi
cations of your glasses and emitter. The following can be
con
fi
gured:
•
Swap Eye
: You can choose to invert the stereo Sync.
•
Dark time
: You can select how much dark time the projected image will have between frames. You can choose one of the
options between 1000 µs and 2500 µs.
•
Sync Delay
: You can increase or decrease the sync delay. The scale goes from –10 000 µs to +10 000 µs with a step of 100
µs.
If a 3D emitter is used that radiates infrared beams (IR beams), the IR beams may interfere with the IR com-
munication between projector and the RCU. If such interference occurs, connect the RCU to the projector
using the remote cable. It is also advised to turn the IR receivers on the projector off to avoid the 3D emitter
interference. To turn off the IR receivers, see "Remote control, on/off button", page 12.
How to adjust the projector to the 3D emitter?
1. In the main menu, select
Installation
→
3D Setup
.
Image 7-60
Installation menu, 3D setup
The 3D setup menu is displayed
Image 7-61
2. Select the desired the stereo Dark Time.
3. Use the slider to set the desired stereo sync delay.
4. If necessary to invert the stereo sync, click the Swap Eye option.
72
R5906102 WODAN 10/04/2018
