4. Getting Started
•
Chosen source
•
Current resolution and refresh rate
•
Device serial number and article number
•
Current
fi
rmware version and model name
•
Current illumination (in percentage)
•
Lamp runtime in hours
•
Chosen communication method and IP address (if connected)
•
Warp status
•
Environmental temperature
Starting image projection
1. Make sure the available sources are connected to the appropriate input ports.
Tip:
If properly connected, the “SYNC” LED will lit up ORANGE.
2. Press the
Input Selection
button on the keypad or on the remote control until:
-
the LED of the selected source (the “SEL” LED) lit up GREEN, and
-
the image of the selected source is projected.
1
2
Image 4-3
4.3
Switching to standby
How to switch to standby
1. Press and hold the
Power on/off
button for 3 seconds on the local keypad, or press the
Power Off
button on the remote control.
The projector goes to standby mode. The after-cooling cycle will start (up to 300 seconds). During this period the Power on/off
button will blink. Once the after-cooling cycle has ended, the projector will be in standby mode and the Power on/off button will
be lit WHITE.
300 s
3 s
Image 4-4
4.4
Power off projector
C
AUTION
:
This procedure assumes the projector is in standby mode.
28
R5906102 WODAN 10/04/2018
