![background image](http://html1.mh-extra.com/html/barco/sim-7qp-hb/sim-7qp-hb_user-manual_4252429040.webp)
5. Setup
Image 5-1
Barco SIM7 : Power switch
L3 and L1 light up red. After the initialization period L1 turns off.
Image 5-2
Image 5-3
Standby state : L3 is red
5.3
Setting the RCU address
What has to be done ?
To allow the communication between the RCU and the projector the RCU has to be programmed with the same address as the
projector.
This address must be in the range 0–9.
To know the address of the projector, one can visualize it in projection mode (on screen) as well as in standby mode (shown with
the LED’s on top cover of the projector).
For more info on addresses see the appendix
At this stage the image projected may happen to be upside down or mirrored, this can be set in the
Installation
menu under
Projector orientation
(see further setting up the projector’s orientation).
Displaying the Projector Address in Standby mode
1. Press the
Address
key (recessed key on the RCU) with a pencil.
36
R59770330 SIM 7QP SERIES 08/12/2014
Summary of Contents for SIM 7QP HB
