![background image](http://html1.mh-extra.com/html/barco/sim-5w/sim-5w_user-manual_4251408043.webp)
5. Setup
5. SETUP
Overview
•
•
Setting up the Remote Control Unit address
•
Setting up the projector address (only if necessary)
•
•
•
Setup the baud rate for serial communication
•
•
Setup of Linked projectors in a Multichannel system
5.1
Powering up the projector
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto
fi
ve minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.
How to power up the projector?
1. Switch the power switch to “1”
2. The software will be initialized. The initialization is followed by the keypad lighting up brie
fl
y and the projector Standby status
5.2
Setting up the Remote Control Unit address
RCU
Remote Control Unit
What has to be done?
To allow the communication between the RCU and the projector the RCU has to be programmed with the same address as the
projector.
This address must be in the range 0-9.
To know the address of the projector, one can visualize it in projection mode (on screen) as well as in standby mode (shown with
the LED’s on top cover of the projector).
At this stage, the image projected may happen to be upside down or mirrored, this can be set in the
Installation
menu under
Projector orientation
(see further setting up the projector’s orientation).
Displaying the Projector Address in projection mode
1. Press the
Address
key (recessed key on the RCU) with a pencil.
R59770324 SIM 5W 22/12/2011
39
Summary of Contents for SIM 5W
Page 1: ...SIM 5W User guide R59770324 06 22 12 2011 Downloaded From projector manual com Barco Manuals ...
Page 54: ...5 Setup 50 R59770324 SIM 5W 22 12 2011 Downloaded From projector manual com Barco Manuals ...
Page 194: ...Index 190 R59770324 SIM 5W 22 12 2011 Downloaded From projector manual com Barco Manuals ...