Downloaded from Projector.com
Getting Started
3-6
5976197 BARCOCINE 7 10012001
Before using the RCU
The RCU is default programmed with address 0 or 1, 'common address'. Regarding to the internal wiring of the RCU the default address
can be 0 or 1 (call for technical assistance to change the common address setting). With that 'common address' programmed into
the RCU, every projector, without exception will listen to the commands given by this RCU. If it is necessary to control a specific
projector, than enter the projector address into the RCU (only when that address is between 0 and 9). The projector with the
corresponding address will listen to that specific RCU.
Common Address
Every projector has a common address '0' or '1'. The choice between '0' and '1' can be selected in the Service mode.
Display the Projector Address on the Screen.
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address will be displayed in a 'Text box' (menu 1).
This text box disappears after a few seconds.
PROJECTOR ADDRESS
001
To continue using the RCU with that specific address, it is necessary to enter the same address with the digit buttons (address between
0 and 9) within 5 seconds after pushing the address key. For example : if the Address key displays projector address 003, then press
"3" digit button on the RCU to set the RCU's address to match the projector's address. Do not press 003 digits. This will address the
remote control to '0' and control all projectors in the room.
If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) and control all projectors in the
room.
How to program an address into the RCU?
Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons within 5 seconds after
pushing the address key. That address can be any digit between 0 and 9.
Controling the Projector
Input selection modes
Source No
Projector input
Press button
1
Comp. Video
1
2
S-Video
2
3
RGBS or RGsB
3
3
RGB3S or RG3sB
4
3
(R-Y)Y(B-Y)S or
(R-Y)Ys(B-Y)
5
3
(R-Y)Y(B-Y)3S or
(R-Y)Y3s(B-Y)
6
Input Selection via the RCU.
With the digit buttons on the RCU, it is possible to select one of the above input modes.
