Connections
3-1
5975188 RETRODATA 808S 210397
3
CONNECTIONS
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector to
the wall outlet. Plug the female power connector into the
male connector on the lower part at the backside of the
projector.
POWER / M AINS
120/230 V
Power Check
The power voltage is determimed by the art. no. listed on sticker on
the back side of the projector.
Warning !
Verify the power voltage corresponds to that of the wall outlet.
Art. No. R9002110 must be connected to a 230 VAC power source.
Art. No. R9002119 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Switching On/Off
The projector is switched ON and OFF using the power (mains) switch
ON/OFF on the local keyboard
To gain access to the local keyboard, refer to 'Front panel terminology'
in chapter 'Location of function of control'.
Pressed : ON
Not pressed : OFF
The projector can start in the 'operational mode' (image displayed) or
in the 'stand by mode', depending on the position of the 'power up' dip
switch on the controller unit. This DIP switch must be set during
installation by a qualified technician. If you want to change this start
up mode, call a qualified technician.
Stand by indication lamp :
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Standby mode.