Barco R9001500, Owner'S Manual

Page: 83 / 86

Service Mode
9-7 5976070 BARCOELM G10 18012000
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
<EXIT> to return.
LAMP
Serial number : R101111
Type : B400049
Run time : 10 hours
Remaining run time : 490 hours
Number of strikes : 10
Center lumens : 10000
menu 2
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
LAMP
MORE...
Lamp
Lamp information.
All information about the lamp is stored inside the lamp house and can be displayed via the projector software on the projection screen.
No information can be changed.
How to display the lamp information.
1 Push the cursor key é or ê to highlight 'Lamp' (menu 1).
2 Press ENTER to select.
The lamp information menu will be displayed (menu 2)
Which information is available ?
Serial number : unique serial number of the lamp.
Type : lamp type.
Run time : total time the lamp is used in this or other projectors.
Remaining run time : time left before the lamp must be replaced
Using the lamp longer than the maximum run time (500 hours) may damage the projector.
Number of strikes : Total times the lamp is started up.
Center lumen : number of lumens in the center of the image.
menu 1
BARCO logo
What can be done ?
The BARCO logo can be added to the image, in overlay or on a background, on any place on the screen.
How to add or the change the settings ?
To add the BARCO logo or to change a setting in the BARCO logo menu:
1 Push the cursor key é or ê to highlight 'BARCO logo' (menu 1).
2 Press ENTER to select.
The BARCO logo menu will be displayed on the screen (menu 2. Within this menu, three toggle settings and a shift control are
available.
SERVICE
BARCO LOGO
PRESET INPUT BALANCE
I2C DIAGNOSIS
MORE...
BARCO LOGO
STATUS :
[
ON
]
BACKGROUND :
[
ON
]
SHIFT
HOT KEY :
[
TEXT
]
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
menu 1
menu 2