Barco R9001500, Owner'S Manual

Page: 18 / 86

3-4
Installation Guidelines
5976070 BARCO ELM G10 18012000
Safety Area around the Projector
Make sure the projector is located so that the air inlets and outlets for the cooling system are not obstructed.
Leave a safety areo of about 1 meter on the left and the right side of the projector.
Installation of the Lamp Casing
Lamp Casing Warnings
Never transport the projector with the lamp casing installed.
The lamp casing should always been transported in a vertical way to avoid damaging the lamp.
Never attempt to disassemble the lamp from its housing or to dispose of it other than by returning it to BARCO. Due to its high internal
pressure, the lamp may explode in either hot or cold state.
Installing the projection lamp.
1 Unplug the projector from the wall outlet.
2 On the input side of the projector, remove the side by turning the 3 bolts a quarter counter clockwise (image 8).
$,5,1
$,5287
6DIHW\DUHDIRUDLULQ RXW
3 Flip the lower side of the plate a little and pull then downward to remove the plate.
4 Take the lamp casing carefully out of its shipping box.
Image 8
Image 7