Barco R9001500, Owner'S Manual

Page: 20 / 86

3-6
Installation Guidelines
5976070 BARCO ELM G10 18012000
4 On the input side of the projector, remove the side by turning the 3 bolts a quarter counter clockwise.
5 Flip the lower side of the plate a little and pull then downward to remove the plate.
6 Turn the retaining bolts of the lamp a quarter clockwise.
7 Pull out the lamp casing. Wear heat resistant gloves, the case can be hot.
8 Pack the lamp casing into the lamp flightcase and transport it verticaly.
Re-adjusting the lamp position in the lamp casing
With higher run times, the light output of the lamp will decrease, which results in a lower light output on the screen.
This light output decrease can be compensated by readjusting the position of the lamp.
As the projector has to be opened, this procedure has to be performed by qualified service technician..
Handle as follow :
1 On the side of the inputs, turn the 3 retaining bolts a quarter counter clockwise.
2 Flip the lower side a little backwards and take off the side cover.
3 Loosen the nut A (image 14) on the back of the lamp casing (nutdriver 10).
4 Adjust the screw B (image14) with an allen key by turning a little clockwise until the maximum light output is reached.
5 Fasten the nut on the back of the lamp casing to secure this position (nutdriver 10).
Lenses
Which Lens has to be selected.
1 Determine the required screen width.
2 Determine the approximate position of the projector in the projection room with regard to the screen and measure the
projector-screen distance (PD).
3 Use the lens formulas to find the best corresponding PD with regard to the measured projector-screen distance for the required
screen width.
The desired lens is determined (the order number is given in the tabel).
Available lenses
QLD lenses :
Name Lens Lenght mm (inch) Diameter mm (inch) Weight kg (lbs) Order number
QLD (1.5-2.0:1) 329 183 R9840130
QLD (2.0-2.5:1) 335.5 160 R9840140
QLD (2.5-4.0:1) 285.7 155 R9840150
QLD (4.0-7.0:1) 383 144.5 R9840160
QLD (1.2:1) 447 183 R9840120
Remark : When using these lenses with the ELM G10, the throw ratio is these for the ELM R12 x 1.25.
LD lenses :
Name Lens Lenght mm (inch) Diameter mm (inch) Weight kg (lbs) Order number
LD (1.5-2.5:1) R9840090
LD (2.5-4.0:1) R9840270
LD (4.0-7.0:1) R9840280
Image 14