Service Mode
9-3
5976072 BARCOELM R12 05052000
- Projector Run Time
: gives the total run time since the first start up. All projectors leave the factory with a run time of approximately
24 hours.
- Projector Serial number : indicates the fabrication number of the projector. This number can be useful when calling for technical
assistance.
Change Password
How to enable or disable the password function ?
The password function is enabled when the password switch, second switch of S2, on the controller module is in the ON position.
To get access to the controller module, proceed as follows :
1 Power down the projector and disconnect the power cord from the wall outlet.
2 On the input side of the projector, remove the side by turning the 3 bolts a quarter counter clockwise (image 1).
3 Flip the lower side of the plate a little and pull then downward to remove the plate.
4 Open the cover door by turning the retaining screw a quarter counter clockwise (image 2).
5 Change the position of S2 (image 3).
About password Types.
3 different password levels are built in, in the projector software.
The different levels are :
owner
user
guest
Depending on your password level some password protected items are accessible and others not.
The owner (which has the highest level) can set up via the 'Access control list' the accessibility of the different items. See 'Access
Control List'.
Image 1
Image 2
Image 3
Summary of Contents for R9001490
