Barco R9001490, Owner'S Manual

Page: 34 / 93

4-9
Connections
5976072 BARCOELM R12 05052000
R G B
H / C
V
On
5*%$1$/2*,1387
98 279
10
Vert. sync
Hor. sync or Composite
sync
Blue
Green
Red
RGB Analog Input Module.
What can be connected to these inputs ?
RGB analog input terminals with separate Horizontal and
Vertical sync inputs(RGB-HV), with Composite sync
input(RGB-S) or with Sync signals on green(RGsB).
Remark
Always use an interface when a computer and local monitor
have to be connected to the projector. See 'slot 1' for
interfaces to be applied.
All input signals are always 75 ohm terminated, even in the "not selected" mode.
How to select the RGB input :
Key in the corresponding slot number on the RCU or the local keypad.
Sync selection on the Input Slots menu.
The horizontal sync input can be set as separate sync input or as separate sync + video input.
To change this setting :
1 Press ADJUST or ENTER key to start up the Adjustment mode.
2 Push the cursor key é or ê to select Installation (menu 1)
3 Press ENTER .
4 Push the cursor key é or ê to select Input Slots (menu 2)
5 Press ENTER .
6 Push the cursor key é or ê to select the corresponding RGB Input Slots (menu 3)
7 Press ENTER key to toggle between CV and CS or HS&VS.
9,'(2,1387
9,'(2 69,'(2
R G B H / C V
On
9
8
27
91
0
R G B H / C V
On
High Bandwidth RGB ANALOG INPUT
R G B H / C V
On
High Bandwidth 5 CABLE INPUT
OUT IN
On
98
40
11
0
6',',*,7$/,1387
OUT IN
On
98
40
11
0
6',',*,7$/,1387
COMM PORT TRIGGER OUT RS232/422 OUT RS232/422 IN
IR-Recei ver Diagnostic Code
Green Operation
Red Stand- by
IR Sync OK
Hardwi red
remote
CTRL 1
Hardwi red
remote
CTRL 2
Two way
hardwired
remote
CTRL 3
21
2))
% +
* 5
9
,13 ,13
,1387
,17(5)$&(
/HYHORIWKHLQSXWVLJQDOV
RGBS/RGsB analog : 5 x BNC
Red : 0.7 Vpp ± 3 dB
Blue : 0.7 Vpp ± 3 dB
Green : 0.7 Vpp ± 3 dB
1 Vpp ± 3 dB if sync on green
Vert. sync : 1 Vpp to 4 Vpp ± 3 dB
Hor. sync / Composite sync :
1 Vpp to 4 Vpp ± 3 dB