Service Mode
11-3
5975207 BARCOGRAPHICS 9100 081196
Change Password
This item is password protected when the password strap is installed.
How to enable or disable the password function ?
The password function is enabled when the password strap on the
controller module is installed.
To get acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver or
coin counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly and
lay it down on the second part of the top cover.
RS232 OUT
IR-ACKNOWLEDGED
IR-RECEIVED
DI AGNOSTI CS
CO DE
IR-RECEIVER
100 - 230 V
9 - 4 A
60 - 50 H z
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to followi ng two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
RS232 OUT
IR-ACKNOWLEDGED
IR-RECEIVED
DI AG NO S TI CS
CO DE
IR-RECEIVER
100 - 230 V
9 - 4 A
60 - 50 H z
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to followi ng two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
Loosen the locking
screws.
Open the top cover
When the strap is on leg 2-3 or no strap is mounted, the password
function is enabled, when the strap is on leg 1-2, the password
function is disabled.
Password enabled
strap on leg 2-3
Password disabled
strap on leg 1-2