Barco Orion 1080, Safety And Users Manual

Page: 55 / 70

55
6.11 Software upgrades
When upgrading the software the projector must always be in standby mode!
If you are or have been in standby ECO mode you MUST use the following procedure before upgrading your
projector:
1. Start the projector
2. Disable the standby ECO mode in the OSD menu
3. Power off (enters standby and not ECO mode)
4. Disconnect and reconnect the power cable
5. Wait
for standby (yellow light)
6. Connect USB cable and proceed with the upgrading process below
To upgrade your projector software follow the method and sequence described below:
1. You will need a USB memory stick set up with a FAT-file system to perform this upgrade
2. Access the upgrade software from www.barco.com
3. Download and save the firmware.zip-file to your PC desktop
4. Download and save the firmware_<version>.tar file to the root of a memory stick
It is important that the USB is safely removed from computer using the eject
function on your PC.
5. Set the projector in standby mode
6. Insert the memory stick in the projector and wait a few seconds
7. If the projector is in standby mode it will start flashing automatically
If the projector is in a sleep mode , push the on button to initiate flashing
Rapid blue blinking indicates that upgrade is initiated
8. Remove the USB stick when blue blinking turns to yellow blink.
Rapid yellow blinking indicates that the upgrade process is running
9. Do not turn off projector/remove the power cable while the upgrade is still in progress!
10. The projector may restart several times during the upgrade
11. The upgrade has finished successfully when yellow rapid blink has changed to solid yellow light