System manual MeDis 5MP1HM
22
Placing and configuring the displays
1 The last part of this system manual is a copy of the display user
manual. Follow the precautions and guidelines from this part.
2 The display(s) from the MeDis system are numbered. E.g., in a
quad-head system, the displays are numbered 1 to 4. You can
find the number of the display on a label at the rear side.
3 In a multi-head system, the order in which you place the displays
is not random: From left to right or from top to bottom in
ascending order.
4 The displays' remote addresses are properly set at the factory.
The addresses correspond to the display numbers on the rear
label: Display #1 has address 1 etc.
Note
: The display address setting can be found in the
Settings
menu in the display's on-screen menus. For more information,
please refer to the last part of this manual.
Connection of the video cables
1 The video cables from the MeDis system are numbered. You can
find the number on a label on the cable.
The cable number must correspond to the head (on the display
controller) and the display it is connected to: E.g., cable #1 must
connect head #1 (on the first display controller) to display #1,
cable #2 must connect head #2 (also on the first board) to display
#2, etc.
2 Plug in the small coaxial connectors of the video cable into the
connectors of the display controller. Plug in the cable connector
marked with green plastic, into the board connector marked with a
green ring (video). Plug in the cable connector marked with black
plastic, into the board connector marked with a black ring
(horizontal or composite sync). Plug in the cable connector
marked with white plastic, into the board connector marked with a
white ring (vertical sync).
3 Plug in the large coaxial connectors of the video cable into the
connectors of the display. Plug in the cable connector marked
with green plastic, into the display connector marked "Video".
Plug in the cable connector marked with black plastic, into the
display connector marked "HS/CS". Plug in the cable connector
marked with white plastic, into the display connector marked "VS".
Display installation
Summary of Contents for MeDis 5MP1HM
