3. Physical installation
3.4
Connecting the projector with the power net
W
ARNING
:
The total electrical installation should be protected by an appropriate rated and readily accessi-
ble disconnect switch, circuit breakers and ground fault current interrupters. The installation shall be done
according to the local electrical installation codes.
W
ARNING
:
Make sure that the voltage range of projector matches with the voltage of the local power net.
C
AUTION
:
The cross-sectional area of the conductors in the Power Supply Cord shall not be less than 4 mm
2
or AWG 10.
Necessary tools
•
Flat torque screwdriver - 4 mm
•
Adjustable wrench
Necessary parts
•
(for 3W+N+PE, 230/400V) Certi
fi
ed power cable, minimum 4 mm² or AWG 10, 500V rated, cable diameter between 11 mm and
21 mm, or
•
(for 3W+PE, 208V) Certi
fi
ed power cable, minimum 4 mm² or AWG 10, 300V rated, cable diameter between 11 mm and 21 mm
•
Circuit breaker - maximum 40A
How to connect the projector with the power net?
1. Remove the back cover of the projector. See "Removal of the back cover", page 88.
2. Remove the power connection cover. See "Access to the power connection", page 19.
3. Loosen the cable gland
fi
xation ring (1).
Note:
The cable gland is speci
fi
ed for cables with a diameter between 11 mm and 21 mm.
4. Push the stripped power supply cable (2) through the cable gland. When using a
fl
exible power cord, make sure each conductor
end is provided with an end sleeve.
5. Secure the cable in the cable gland by tightening the
fi
xation ring with an adjustable wrench.
6. Connect each wire of the power cable with the terminal barrier strip (3), according to the legend on the decal (4). Tighten the
screws to a torque of
1.4 Nm
.
Warning:
Always connect ground conductor (PE)
fi
rst.
Note:
Always connect the neutral conductor (N) when available.
L1
L2
N
L3
1
2
3
4
Image 3-7
Power connection
7. Install the power connection cover.
8. Install the back cover of the projector. See "Removal of the back cover", page 88.
22
R5905823 HDQ 4K35 30/11/2015
Summary of Contents for HDQ 4K35
