Barco Galaxy NH-12, User Manual

Page: 183 / 193

9. Troubleshooting
Galaxy NH-12
Troubleshooting
NO POWER
BACK TO
STANDBY
NO IMAGE
ARTEFACTS
POOR IMAGE
NO CONTROL
POWER CORD NOT HOT
Check external power supply
Replace the power cord
POWER CORD NOT PLUGGED
Plug in the power cord
MAINS SWITCH OFF
Switch ON
TEMP. OUT OF RANGE
Cool down the room
HUMIDITY OUT OF RANGE
Bring humidity down
VERY HIGH ALTITUDE
Place projector within tilt range
LAMP
PROJECTOR TILT
Replace lamp
LAMP ON
LAMP OFF
NO SOURCE SELECTED
NO SOURCE SIGNAL FOUND
NOT CONNECTED
PROJECTOR IN STANDBY
Replace lamp
Select a source
Connect a source
Check wires and connectors
Check image generator
Switch to active state
STRETCHED / SHRUNK IMAGE
Set Aspect ratio
WRONG ORIENTATION
Set the Orientation
FLICKERING IMAGE
Replace lamp
Switch on LFR
NOISE IN THE IMAGE
Check cabling and connections
Check the IG
BAD ZOOM
Adjust lens zoom
BAD FOCUS
Adjust lens focus
BAD SOFT EDGE
BAD BRIGHTNESS or CONTRAST
Set Brightness / Contrast
Clean the projector lens
ELECTRONIC SOFT EDGE
Enable Soft edge
Set Lamp power mode to Normal
NO RCU CONTROL
Remove blocking objects
Program the correct address
Insert new batteries
Image 9-13
R59770121 NH-12 04/05/2011 179