Barco F90-W13, User Manual, Page: 18 / 57

2. Getting to know the projector
Projector Front
1
1
2
1
2
6
3
4
8
7
1
2
1 9
5
5
Image 2-2
1
LED status light
2 Adjustable feet
3 Projector lens
4 Lens holder
5 IR Receiver: for remote control communication
6 LCD panel
7 Keypad
8 Connector panel
9 Front USB and triggerboard
2.2 Service and maintenance
General
The F90 does not have any user-serviceable parts.
All service tasks must only be carried out by the manufacturer, or a Barco authorized service personnel or Barco technicians.
The projector color wheel can be replaced by users in the fi eld. See "Change the color wheel ", page 17 for more information.
2.3 LED status light
About
The F90 status is located on the top side of the projector, near the IR receiver (ref. 1, image 2-2).
During normal operation the LED is unlit. In the event of a critical error or high temperature, the LED will display red.
By critical error, the projector cannot be restarted until the projector is disconnected from the power supply and then reconnected
again. If the reason for the error persist, the projector will again go to critical error status.
By high temperature, the projector will restart when it has cooled down, and temperatures are back within the normal operating
limitations.
2.4 LCD panel
About
The LCD panel (reference 1, image 2-3) is located on the right side of the projector. It shows the following information for the
projector, and is a mirror of the OSD. (On Screen Display)
• Projector status
• Network address
• Active source
• Current fi rmware version
14 601–0400–00 F90–W13 18/08/2016