Barco Eonis MDRC-2324, User Manual

Page: 11 / 38

R5910550 /00 Eonis 11
Image 2-4
4. If necessary for your application, earth the MDRC-2324 by connecting the earth pin to a grounded outlet by
means of a yellow/green AWG18 wire (maximum admitted cable length according to national regulation
requirements).
Image 2-5
5. Route all cables through the provided cable routing clip at the back of the display stand.
2.2 Display position adjustment
To adjust the display position
You can safely tilt, pivot, raise and lower the display as desired.
WARNING: The display must be in its highest position before it can be properly pivoted.
The standard orientation of the video input is landscape. If you use the display in portrait mode,
make sure you change the orientation of the video input via the screen settings of the computer.
2.3 VESA-mount installation
To mount the display on a VESA arm
The display panel, standard attached to the stand, is compatible with the VESA 100 mm standard.
1. Unscrew the four fixation screws to detach the panel from the stand.
2. Use 4 M4 screws to attach the panel to a VESA approved arm. Please respect the following rule to select
an appropriate screw length:
• L
min
= T + W + 8 mm
• L
max
= T + W + 14 mm
Installation