Barco DP2K-19B, Installation Manual

Page: 36 / 125

4. Lamp & Lamp House
C
AUTION
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
handled.
Necessary tools
10mm nut driver or fl at screw driver.
How to remove the Lamp House from the projector?
1. Make sure the projector is switched off and cooled down.
2. Remove the cover of the Lamp House compartment.
3. Release the two retaining screws (reference 1 image 4-5) at the base of the Lamp House. Use a 10mm nut driver or a fl at screw
driver.
4. Remove the Lamp House as follows:
a) Grip the Lamp House by the bottom handle and partially slide it out of the lamp compartment
b) Grip the Lamp House by both handles and remove it completely from the projector.
c) Place the Lamp House on a stable support.
Caution: Be aware of the weight of the lamp assembly. Take the necessary precautions to avoid personal injury.
1
Image 4-5
This procedure is illustrated with a Motorized Lamp House. Nevertheless, the instructions are also applicable
for the manual Lamp House.
4.4 Removal of the xenon lamp from manual S/M Lamp House
W
ARNING
:
DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XENON LAMP.
W
ARNING
:
This procedure may only be performed by quali fi ed technical service personnel.
30 R5905067 DPXK-19B/23B/P 17/09/2012