Barco Coronis 5MP Mammo, Getting Started Manual

Page: 29 / 88

Display Controller Installation
29
Types of display controllers for Barco Display Systems
The following models of Barco display controllers are available for
your display system. Please check which of the following models is
delivered with your system, and follow the corresponding installation
instructions:
*
Recommended PCI/PCIe slot
Note:
You can use x16 & x8 slots for x1, & x4 boards.
If you are using a display controller with a VGA jumper, you will need
to decide if you are going to use its on-board VGA capabilities. If you
are, check the setting of the Jumper at J-1 on the display controller
(see figure 3). By default, VGA should be enabled, on the top two
pins. To disable the on-board VGA capabilities move the jumper so
that it is on the middle and bottom pins.
Board Model VGA Jumper Compatible PCIe/PCI Slot
Barco MXRT 1150 No x1*, x8, x16
Barco MXRT 2100 No x16
Barco MXRT 2150 No x16
Barco MXRT 5100 No x16
Barco MXRT 5200 No x16
Barco MXRT 7100 No x16
Barco MXRT 7200 No x16
Barco MXRT 7300 No x16
B
ARCO
M
ED
C
ORONIS
PCIe Yes x8*, x16
B
ARCO
M
ED
C
ORONIS
PCI Yes PCI 32 or PCI 64*
B
ARCO
M
ED
N
IO
PCIe Yes x8*, x16
B
ARCO
M
ED
N
IO
PCI Yes PCI 32 or PCI 64*
B
ARCO
M
ED
5MP2FH PCIe Yes x8*, x16
B
ARCO
M
ED
5MP2FH PCI Yes PCI 32 or PCI 64*