Barco Coronis 3MP LED MDCG-3221, User Manual

Page: 25 / 56

K5902060 /09 Coronis 3MP LED Display
25
Hibernate can only be enabled on your display when the DPMS mode is enabled first. Therefore,
please refer to
“ DPMS mode ” , page 24 to do this.
Please connect your keyboard or mouse to your PC rather than to the display's USB ports when
hibernate is enabled.
To enable/disable hibernation on your display:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and confirm.
To specify the hibernate time-out:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the time-out value as desired and confirm.
4.10 I-Luminate default mode
About the I-Luminate default mode
The I-Luminate default mode defines the default activated mode during the I-Luminate boost. This mode is:
Screen The boost mode is applied on the screen display.
To enable/disable I-Luminate:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > I-Luminate menu.
3. Enter the Default mode submenu.
4. Select Enabled / Disabled as desired and confirm.
4.11 Luminance target
About the luminance target
The luminance target of your Coronis 3MP LED Display is adjustable over a predefined range. When you
change the luminance target, the display will adjust its backlight to reach the target.
To set the luminance target:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Calibration menu.
3. Enter the Luminance Target submenu.
4. Set a luminance target value as desired and confirm.
The default, factory DICOM calibrated luminance value is available in the technical specifications
table. The guaranteed backlight lifetime is valid for this setting.
Advanced operation