Barco Coronis 3MP LED MDCG-3221, User Manual

Page: 13 / 56

K5902060 /09 Coronis 3MP LED Display
13
Image 2-8
To Reattach the connector compartment cover
1. Reattach the connector compartment cover by sliding the cover's bottom in position and then push the cover's
top. You'll hear a
“ click ” sound of the cover's clips when the connector compartment cover is in position.
Image 2-9
2.6 VESA-mount installation
WARNING: Never move a display attached to an arm by pulling or pushing the display itself.
Instead, make sure that the arm is equipped with a VESA approved handle and use this to move the
display.
Please refer to the instruction manual of the arm for more information and instructions.
WARNING: Use an arm that is approved by VESA (according to the VESA 100 mm standard).
Use an arm that can support the weight of the display. Refer to the technical specifications of this
display for the applicable weight.
Overview
The panel, standard attached to the tilt & swivel foot, is compatible with the VESA 100 mm standard. So it can
be used with an arm stand according to the VESA 100 mm standard.
Therefore, the tilt & swivel foot must be removed from the panel.
1. Fasten the height mechanism of the foot by putting the red clip in the hole “ Unlocking the height
mechanism ” , page 10.
Display installation