Barco CLM R10+, User Manual

Page: 148 / 229

13. Projector control
Image 13-28
13.4.5 Default Gateway set up
How to set up?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER .
3. Use the ▲ or ▼ key to select Network and press ENTER .
The Ethernet menu opens.
4. Use the ▲ or ▼ key to select Default Gateway and press ENTER to select.
Note: An address contains 4 octets with a maximum value of 255.
Set the default gateway to the IP-address of the router (MUST be on the local subnet!). If there is no router on the projector’s
local subnet then just set this
fi eld to any IP-address on the subnet.
5. Use the ▲ or ▼ key to select the desired digit and press ◄ or ► key to select the next digit in the address.
Or,
enter the value with the digit keys on the remote control or local keypad. The next digit in the address will be selected automati-
cally. (image 13-29, image 13-30, image 13-31, image 13-32)
Note: This must NOT be 0.0.0.0
6. Press EXIT to return.
Image 13-29
Image 13-30
Image 13-31
Image 13-32
13.5 IR control switching
What can be done?
Each IR receiver inside the projector can be activated or deactivated. When an IR receiver is deactivated, no IR signal send to this
IR receiver will be processed. When entering an Activation code with the remote control all IR receivers can be activated at the
same time.
How to switch
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER .
3. Use the ▲ or ▼ key to select IR Control and press ENTER .
144 R59770021 CLM R10+ 11/10/2010