Barco Baron 908 R9040060, Owner'S Manual

Page: 73 / 100

Service mode
6 - 5 5976419 BARON 908 04122001
Change baudrate
What can be set up ?
The communication speed between projector and computer has 8 possible speeds. The baud rate speed can be software set up.
The following baud rates are available :
- 38400, 19200, 9600, 4800, 2400, 1200.
Note: The default baudrate is 9600 Baud.
How to set up ?
To set up the baudrate :
1. Push the cursor key é or ê to highlight 'Change Baudrate' (menu 1).
2. Press ENTER to select.
The actual baud rate will be highlighted (menu 2)
3. Push the cursor key é or ê to select the desired baudrate.
4. Press ENTER to accept.
Projector warm up
What can be done ?
When in the ON position (and the CRT run in cycle is OFF), the projector can start up with a warm up periode. The warm up time
can be set up by the customer as well as the frequency of the warm up source.
During the start up a warm up menu will be displayed. This menu offers the possibility to skip the warm up periode anyway by pressing
the EXIT key and offers the possibility to adjust the horizontal and vertical amplitude of this white image with the cursor keys. During
this warm up period, a full white image is shifted on the CRT faceplate to avoid a burn in.
Every 30 seconds a text box will be displayed in another place on the screen with the remaining time to go.
When EXIT is pressed during this warm up periode, the warm up menu will be redisplayed with the remaining time indication. Press
another time EXIT to interrupt the warm up cycle.
When the warm up option is OFF, when switching on the projector, it starts immediately with the projection of the selected source.
Note: When the warm up period is interrupted, the projector is not ready to perform in optimum condition.
How to select ?
1. Push the cursor key é or ê to highlight 'Projector Warm up' (menu 1).
2. Press ENTER to select.
The projector warm up menu will be displayed (menu 2).
Select with é or ê
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0
<ENTER> to accept
<EXIT> to return.
BAUDRATE
Select new
baudrate :
38400 19200
9600 4800
2400 1200
Select with arrow
keys ;
menu 1
menu 2
PROJECTOR WARM UP
WARM UP : ON
FREQUENCY : 64 kHz
TIME : 15 min
A FULL WHITE PATTERN
WILL BE GENERATED AT
POWER UP
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
CONDITION
with <ENTER>
<EXIT> to return
menu 2
Select with é or ê
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
menu 1
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0