20
Manually Lighting Your Grill by Match
To light your gas grill by match, Follow steps 1
through 6 of the Basic Lighting Procedures. Then,
light the match and place near the top end of
Lighting Tube on the right side of the grill. See
Figure 7
. Turn the nearest Main Burner Control
Knob to the HIGH setting to release gas.
The Burner should light immediately.
To purge air from your gas line and/or
reset the Regulator excess gas flow device:
Opening the tank valve all the way or too quickly is
what triggers the Regulators safety device to shut
down gas flow which prevents excessive gas flow to
your grill. Lighting the Burner farthest from the fuel
source every time will help eliminate air pockets in
the Manifold. This procedure should be done every
time a new LP gas tank is connected to your grill:
Never
lean over the grill cooking area while
lighting your gas grill. Keep your face and body
a safe distance (at least 18 inches) from the
Lighting Hole or Burners, when lighting your
grill by match.
WARNING
!
•
•
•
2.
3.
Misalignment of Burner Tubes over Orifices
Correction:
Reposition Burner Tubes over Orifices.
Obstruction in gas line
Correction:
Remove fuel line from grill. Do not
smoke! Open gas supply for one second to clear
any obstruction from fuel line. Close off gas supply
at source and reconnect fuel line to grill.
Plugged Orifice
Correction:
Remove Burners from grill by
pulling Cotter Pin (beneath Burner) using Long
nose pliers. Carefully lift each Burner up and
away from Gas Valve Orifice. Remove the Orifice
from Gas Valve and gently clear any obstruction
with a fine wire. Then reinstall all Orifices,
Burners, Cotter Pins and cooking components.
If an obstruction is suspected in Gas Valves or
Gas Valve Bracket, please call
B a r b e q u e s G a l o r e a t 1 - 8 0 0 - 4 7 4 - 5 5 8 7 .
Turn gas off at source and turn the Control Knobs
to OFF. Wait at least five minutes for gas to clear,
then retry.
Check gas supply and connections.
Repeat lighting procedure. If your grill still fails
to operate properly, turn the gas off at source,
turn the Control Knobs to OFF, then check the
following:
If the grill fails to light properly:
1.
•
•
•
Misalignment of Ignitor on Burner
Correction:
Check for proper position of the
Electrode Tip as shown on page 15
.
The gap
between the Spark Electrode Tip and
Spark Receiver should be approximately
3/16". Adjust if necessary following the
Electrode Check procedure on page 15.
Disconnected Ignition Wires
Correction:
Inspect the Ignitor Junction
Box found behind the Control Panel. Connect
loose Ignitor wires to Junction Box and try
to light grill.
Weak AA battery
Correction:
Unscrew the Ignitor Cap and replace
the battery.
•
Shut off gas supply to the gas grill.
•
Turn the Control Knobs to OFF position.
•
Put out any flame with a Class B fire
extinguisher.
•
Open Grill Lid.
•
Once the grill has cooled down, clean
the Burner Tubes and Burners according
to the cleaning instructions found on
page 21 in this manual.
Should a "FLASH-BACK" fire occur in/
or around the Burner Tubes, follow the
instructions below. Failure to comply
with these instructions could result in a
fire or explosion that could cause
serious bodily injury, death, or property
damage.
WARNING
!
Figure. 7
Turn all Control Knobs to the OFF position.
Turn off the LP gas tank valve at the tank
valve.
Disconnect Regulator from LP gas tank.
Let unit stand for 5 minutes.
Reconnect Regulator to the LP gas tank.
Open Grill Lid or Side Burner Lid.
Turn the LP gas tank valve on slowly until
1/4 to 1/2 open.
Light the Burner farthest from fuel source by
turning its Control Knob to IGN then pushing
in the Control Knob. To light the Side Burner
push its Control Knob in and turn to HIGH.
LIGHTING
TUBE
MATCH
Summary of Contents for Turbo select G5STR
Page 2: ......
