13
6
Install Partition Panel
Partition Panel
(above the Gas Tank)
Fig. 6
Vent Openings must
be at least 1/8" wide
The gas grill is designed for use with a maximum of 20 lb tank. As per standard, a partition panel
(not included) or equivalent device is required to be installed in the left cabinet of the island for
preventing the use of 30 lb tank.
Note:
Make sure there is 22~24" of clearance between the partition panel and tank tray set. The
space around the gas tank is not greater than 12".
Tank Tray Set
5"
22-24"
21"
1"
17-19"
5"
5"
Install Regulator, Tank Tray Set and Liquid Propane(LP) Gas Tank
Note: The connector, for safety consideration, we suggest to use a stainless steel flexible connector.
But, if using semi-rigid tubing, do not use materials made of aluminum or aluminum alloy tubing. The
connector should be installed visible when opening the door.
On the proper location, drill 2 holes on the island left side panel for installing the regulator bracket. Then
install the regulator using 2 Pan Head Screws 3/16"x3/8" and tighten securely.
On the proper location, drill 3 holes on the island left bottom panel for installing the tank tray set. Then
install tank tray set using 3 Pan Head Screws 3/16"x3/8" and tighten securely.
Connect the stainless steel flexible connector to the manifold and regulator, then use a clamp to fix the
stainless steel flexible connector as shown to secure.
Place the LP gas tank into the tank tray set. Make sure the tank valve facing the right rear corner of left
island. Tighten the wing bolt to secure the LP gas tank. (
See Fig. 5
)
Connect the LP regulator onto the LP gas tank.
CAUTION:
There shall be a minimum clearance of 2 inches (50.8 mm) between the floor of the LP-gas cylinder
enclosure and the ground.
5
Pan Head Screw
3/16"x3/8"
Qty. 5
Part # S182G03061
Island Bottom Panel
Tank Tray Set
LP Gas Tank
Stainless Steel Flexible Connector
(Not provided) must comply with the
Standard for connectors for Outdoor Gas
Appliances and Manufactured Homes,
ANSI Z21.75
•
CSA 6.27, and suitable for
outside installation.
The maximum length of the connection
shall be 6ft.(1.82m).
Regulator Bracket
Fig. 5
5/8" UNF male
thread
clamp
(Not provided)
